Car Plastic Underbelly Rivet
Makerworld ยท Ladle
DescriptionThis is a rivet designed to hold the plastic underbelly of a car up to the chassis, much like the black store-bought version (shown in the cover photo). It was designed with the 2003-2008 Toyota Corolla in mind, but can likely be used on the vast majority of vehicles. I highly recommend that PLA is NOT used to print this, as the heat radiated from roads in most areas can be enough to at least deform it. A good recommendation for filaments:PETG (any)Anything else with a heat resistance above 69 degrees Celsius FULL DISCLOSURE: This is my model. It is also uploaded on Printables by an account I own. This is not considered the original model, although the geometry is identical.
MaterialPETG
Color#000000
Estimated Print Time14m
Estimated Weight1.00 g
Build VolumeNot available yet
Nozzle0.40 mm
Plates1
Remote Print ProjectAvailable
ADD TO CART
7.50 EURREQUEST PRINT
This product can also be submitted as a print request if you need a manual review before ordering.
WhatsApp: +40 799 180 360
STR. PRINCIPALA 1, Bacau, Romania
General: info@h4r.biz