push in rivet, pin, clip automotive 6, 7, 8, 10 mm
Makerworld · TomTTU
DescriptionStep-by-step:Place the insert so that it protrudes from the head side of the pin.Put the pin into the hole.Push the insert until it is flush with the pin’s head.To remove the pin, push the insert inward — the pin will unlock and can be withdrawn.Printing notes:Print at least two parts at a time to improve cooling.For the inserts, I suggest using a brim.Use filament with good layer adhesion.For indor aon oudor stuff PLA is good enough.For higher temperature resistance, I recomend to print with PET, PC, PA or BAMBU TPU for AMS.Important:Avoid using old or moisture-exposed filament.Aged filament is usually much more brittle and has noticeably worse layer adhesion than fresh material.I strongly recommend against using old leftover filament for these parts.
MaterialPLA
Color#FFFFFF
Estimated Print Time1h 00m
Estimated Weight9.00 g
Build VolumeNot available yet
Nozzle0.40 mm
Plates4
Remote Print ProjectAvailable
ADD TO CART
7.50 EURREQUEST PRINT
This product can also be submitted as a print request if you need a manual review before ordering.
WhatsApp: +40 799 180 360
STR. PRINCIPALA 1, Bacau, Romania
General: info@h4r.biz